MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 143 of 207

MWO 5--2350--262--35--4

5--8

SECTION II INSTALLATION AND PRELIMINARY ROUTING OF HDC CABLE

ASSEMBLIES -- CONTINUED

NOTE

Steps r and s below apply to Figure 5--5. Reference should also be made to FO 5--2.

r.

While standing in bowl area, uncoil single connector end J1 (2) of lower cable assembly W3, 12496955,

(1) and feed cable assembly up through access cover opening in upper portion of bowl area (created by

removal of access cover modified in Chapter 3, Section V) into driver’s compartment in same manner as

for upper cable assembly W2.

s.

Carefully route cable connector W3J1 up through access cover opening to back of umbilical cable

disconnect bracket, 12496964, (3) as shown on Figure 5--5.

NOTE

Step t below applies to FO 5--2.

t.

Orient large key (1) of cable connector W3J1 at 12 o’clock position and place in right most opening in

umbilical cable disconnect bracket (3) as shown for a typical connector in Figure 5--2.

FO 5--2. Lower Cable Assembly W3