MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 145 of 207

MWO 5--2350--262--35--4

5--10

SECTION II INSTALLATION AND PRELIMINARY ROUTING OF HDC CABLE

ASSEMBLIES -- CONTINUED

NOTE

Steps v and w below apply to Figure 5--6. Reference should also be made to FO 5--3.

v.

From inside driver’s compartment, uncoil single connector end J1 (3) of power cable assembly W1,

12496953, (1) and place as shown in Figure 5--6.

w.

Carefully place cable connector W1J1 near back of umbilical cable disconnect bracket, 12496964, (2).

NOTE

It may be necessary to file a small notch in left most opening in umbilical cable

disconnect bracket to allow the three “ears” on connector W1J1 to pass through opening

in bracket.

NOTE

Step x below applies to Figure 5--6.

x.

Orient large key (1) of cable connector W1J1 at 12 o’clock position and place in left most opening in

umbilical cable disconnect bracket (3) as shown for a typical connector.

FO 5--3. Power Cable Assembly W1

NOTE

Step y below applies to Figure 5--6.

y.

Uncoil remainder of power cable assembly W1 and route 1070 branch of cable to parking brake relay

area in front portion of driver’s compartment.

Figure 5--6. Initial Routing of Power Cable Assembly W1