MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 140 of 207

MWO 5--2350--262--35--4

5--5

SECTION II INSTALLATION AND PRELIMINARY ROUTING OF HDC CABLE

ASSEMBLIES -- CONTINUED

NOTE

Steps e through p apply to Figure 5--3.

e.

Position nutplate, M85049/95--22A, (2) over upper cable assembly W2J1 end of cable (3) at center

location on back of umbilical cable disconnect bracket (7). Place dustcap lanyard (4) behind top left

screw on connector (6) between connector and bracket. Refer to Figure 5--3 for illustration of typical

connector installed on umbilical cable disconnect bracket (7).

f.

Attach upper cable assembly connector W2J1 (3) and dustcap lanyard (4) to nutplate (2) using four

screws, MS24667--4, (1).

g.

Place dustcap, D38999/33W23R, (5) over exposed cable connector W2J1.

h.

Ensure upper cable assembly W2 (8) is not bent or twisted during installation on umbilical cable

disconnect bracket (7).

Figure 5--3. Typical Cable Connector Installation