MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 149 of 207

MWO 5--2350--262--35--4

5--14

SECTION IV ROUTING AND ELECTRICAL CONNECTION OF POWER

CABLE ASSEMBLY W1 -- CONTINUED

NOTE

Step c below applies to Figures 5--10 and 5--11.

c.

Route 1069 branch of cable W1 from disconnect bracket to the wall of the operator’s compartment just

above the NBC filter, as shown in Figures 5--10 and 5--11.

d.

Cut excess cable, install terminal lug, MS25035--154, and crimp onto end of cable W1.

e.

Remove bolt along with existing ground wires from compartment wall. Do not remove existing ground

wires from bolt.

f.

Install 1069 branch of cable W1 on end of bolt and reinstall bolt with wires to compartment wall as shown

in Figure 5--11.

g.

Secure 1069 branch of cable W1 wiring to vehicle as necessary using tiedown straps, MS3367--1--9, and

by routing cable through existing cable clamps. It is not necessary to remove cable clamps during cable

rounting process.

Figure 5--10. Routing Cable Assembly W1 Branch 1069 From Disconnect Bracket