TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 262 of 1060

TM 5-5420-202-20-3

ENGINE HIGH OIL PRESSURE TRANSMITTER REPLACEMENT (Sheet 3 of 3)

INSTALLATION:

NOTE

Prior to installation, lightly coat male threads of all compo-

nents with sealing compound.

1. Using pipe wrench, install elbow (A) to engine.

2. Using 3/4 inch wrench, install pipe bushing

(B) to elbow (A).

3. Using 7/8 inch wrench, install new transmitter

4.

5.

6.

(C) to pipe bushing (B).

Push socket of rubber insulated connector (D) into transmitter cap (E).

Remove rags from under engine high oil pressure transmitter.

Connect engine for powerplant ground hop (page 5-26).

7. Start and run engine. Observe oil pressure indicator for normal oil pressure

(TM 5-5420-202-10).

8. Shut down engine. Disconnect engine from powerplant ground hop (page 5-40).

9. Install powerplant (page 5-14).

End of Task

TA249164

10-223