TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 257 of 1060

TM 5-5420-202-20-3

HEADLIGHT ADJUSTMENT (Sheet 2 of 2)

9.

10.

11.

12.

13.

14.

15.

16.

17.

18.

Turn on service drive headlights, low beam

(TM 5-5420-202-10).

Center of maximum light intensity should be

centered on line (D).

If not, using 9/16 inch wrench, loosen three screws

(G) and adjust by tilting headlight (H) to desired

angle.

NOTE

Adjust both left and right

headlights in same manner.

Using 9/16 inch wrench, tighten three

screws (G).

Check to see if light intensity for left headlight is

centered on intersection of lines (D and E).

If not, using 7/16 inch wrench, loosen three screws

(J) at base of headlight.

Turn headlight (H) until in proper position.

Using 7/16 inch wrench, tighten three screws (J)

when adjusted.

Repeat steps 13 through 16 for right headlight

using lines (D and F).

Turn off lights (TM 5-5420-202-10).

End of Task

10-218

TA249159