TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 954 of 1060
TM 5-5420-202-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 17 of 22)
90.
90.
92.
93.
94.
95.
96.
Using 9/16 inch wrench, remove screw
(AV).
Position steering rod end (AT) in clevis
(AU) and using 9/1 6 inch wrench, install
screw (AR).
Using torque wrench tighten screw (AR)
to 16 lb-ft (22 N.m).
Using 9/16 inch wrench to hold steering
rod end (AW), use 9/16 inch wrench to
loosen jamnut (AX).
Using 9/16 inch wrench, turn steering rod
end (AW) counterclockwise until screw
(AV) will drop freely through clevis (AY)
and steering rod end (AW).
Using small gage wire, check if control
rod (AZ) is past witness hole in steering
rod end (AW). If control rod (AZ) is past
witness hole, go to step 96. If control rod
(AZ) is not past witness hole, go on to
step 99.
Using 9/16 inch wrench to hold steering
rod end (AW), use 9/16 inch wrench to
tighten jamnut (AX).
Go on to Sheet 18
TA249670
15-4 7
Back to Top
