TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 953 of 1060

TM 5-5420-202-20-3

STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 16 of 22)

Using small gage wire, check if control

rod. (AS) is past witness hole in steering

rod end (AT).

If control rod (AS) is past

witness hole, go on to step 85. If control

rod (AS) is not past witness hole, go on to

step 88.

Using 9/16 inch wrench to hold steering

rod end (AT), use 9/16 inlch wrench to

tighten jamnut (AQ),

Position steering rod end (AT) in clevis

LEFT SIDE OF HULL

(AU) and using 9/16 inch wrench, install

(TO REAR OF FUEL

screw (AR.).

Using socket and torque wrench, tighten screw (AR) to 16 lb-ft (22 N.m).

Go on to step 109.

TANK)

Using 9/16 inch wrench, turn steering rod end (AT) clockwise until control rod (AS)

is just past witness hole in steering rod end (AT).

Using 9/16 inch wrench to hold steering rod end (AT), use 9/16 inch wrench to tighten

jamnut (AQ).

Go on to Sheet 17

15-46

TA249669