TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 956 of 1060

TM 5-5420-202-20-3

STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 19 of 22)

104.

105.

106.

107.

108.

Using 9/16 inch wrench to hold steering

rod end (BB), use 9/16 inch wrench to

loosen jamnut (BC).

Using 9/16 inch wrench, turn steering rod

end (BB) counterclockwise until screw

(BA) will drop freely through clevis (BD)

and steering rod end (BB).

LEFT OF DRIVER, S STATION

Using 9/16 inch wrench to hold steering rod end (BB), use 9/16 inch wrench to tighten

jamnut (BC).

Using 9/16 inch wrench, install screw (BA) through clevis (BD) and steering rod end

(BB).

Using socket and torque wrench, tighten screw (BA) to 16 lb-ft (22 N.m).

109.

Using 9/16 inch wrench, loosen jamnut

(BE).

110.

Using hands, turn control rod (BF) coun-

terclockwise until control rod (BF) is not

past witness hole in steering rod end (BG).

LEFT SIDE OF HULL

(TO REAR OF FUEL TAN

Go on to sheet 20

K)

TA249672

15-49