TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 951 of 1060

TM 5-5420-202-20-3

STEERING CONTROL

71.

72.

73.

74.

Using 9/16 inch

LINKAGE ADJUSTMENT (Sheet 14 of 22)

wrench, turn steering rod

end (AB) counterclockwise until screw

(AA) will drop freely through clevis (AE)

and steering rod end (AB).

Using 9/16 inch wrench, install screw

(AA).

Using torque wrench and crowfoot, tight-

en screw (AA) to 16 lb-ft (22 N.m).

LEFT OF

Using 9/16 inch wrench to hold steering rod end (AB), use 9/16

jamnut (AC).

DRIVER’S STATION

inch wrench to tighten

NOTE

Do not remove locater pins already

installed.

75.

Try to insert locating pin (A). If locating

pin (A) can be inserted, linkage is in adjust-

ment. Go on to step 128. If locating pin

(A) cannot be inserted, remove powerplant

(page 5-2) and go on to step 76.

LEFT SIDE OF TRANSMISSION

Go on to Sheet 15

15-44

TA249667