TM-9-2320-209-10-1

2 1/2-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; OPERATION, INSTALLATION AND REFERENCE DATA; OPERATOR LEVEL

SEPTEMBER 1980

TM-9-2320-209-10-1 - Page 387 of 549

TM 9-2320-209-10-1

FRAME 3

Soldier A 1.

2.

Soldier B 3.

Soldier A 4.

GO TO FRAME 4

Put winch cable loop (1) into square auger mounting hole (2).

Put auger-to-holder pin (3) into hole in auger (4), through loop (1) and

into other side of hole in auger.

CAUTION

Never move winch control lever to off position when there

is a load on winch. This will cause the load to drop.

Be sure that winch cable does not bind against derrick sheave

cover while lifting auger and moving auger to rear of truck.

Guide auger with a tag line after auger is lifted from body.

Operate rear winch. Refer to para 4-15d. Lift auger no higher than

necessary to move it to rear of truck.

Guide auger with tag line.

4-333