TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 445 of 830

TM 9-2320-209-20-3-1

FRAME 4

1.

Push generator (1) toward firewall as shown. Front flange on generator

must be hard against front flange on mounting bracket (2).

2.

Put 0.005-inch feeler gage between rear flange on generator (1) and shims

between rear flange on mounting bracket (2). Feeler gage should fit between

flanges very easily.

NOTE

Hold rear of generator (1) up when sliding bolt (3)

out of flange to put in shims (4).

3.

Pull bolt (3) out of rear flange on generator (1). Slip shims (4) between

generator flange and rear flange on mounting bracket (2). Put bolt back in.

4.

Do steps 1, 2 and 3 again as necessary,

adding shims (4) until feeler gage

makes snug fit between shims (4) and rear flange on generator (1).

5.

Screw two nuts (5) on bolts (3 and 6) finger tight.

6.

Using torque wrench, tighten nuts (5) to 65 to 70 pound-feet.

GO TO FRAME 5

7-9