TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 450 of 830

TM 9-2320-209-20-3-1

7-4. ALTERNATOR AND PULLEY REMOVAL

TOOLS:

Flat-tip screwdriver

0.005-inch feeler gage

7/16-inch socket wrench

Torque wrench, 150

pound-feet capacity

Torque wrench, 200

pound-inches capacity

SUPPLIES:

Solvent, dry cleaning, type

Silicone dielectric compound,

AND REPLACEMENT.

Mechanical puller

Strap wrench

3/4-inch wrench

1/2-inch wrench

5/8-inch wrench

15/16-inch wrench

9/16-inch wrench

II (SD-2), Fed. Spec P-D-680

MIL-S-8660B

PERSONNEL: One

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

a.

Preliminary Procedures.

(1) Disconnect battery ground cable. Refer to para 7-58.

(2) Open hood and right side panel. Refer to TM 9-2320-209-10.

b.

Removal.

FRAME 1

NOTE

Cover mounting screws (1) may be at the rear of cover

on some alternators.

1.

Using screwdriver, unscrew and take out two screws and lockwashers (1).

2.

Lift off terminal cover (2).

3.

Using screwdriver,

unscrew and take out two screws and lockwashers (3).

4.

Take off hold down clamp (4).

GO TO FRAME 2

7-14