TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 448 of 830

TM 9-2320-209-20-3-1

FRAME 2

1.

2.

3.

4.

5.

Put male

WARNING

Be very careful when using jumper wires (2). Shorting

wire to ground can burn connector pins or wiring and

cause injury to personnel and damage to equipment.

pin (1) of jumper wire (2) into pin B of generator receptacle (3).

Put female connector (4) of jumper wire (5) onto pin A of chassis wiring

harness connector (6).

Holding jumper wire (2) in one hand and jumper wire (5) in the other,

briefly strike wires together. Do not let them stay together.

NOTE

Chassis wiring harness connector (6) was taken off voltage

regulator at start of task.

Disconnect battery ground cable. Refer to para 7-58.

Take away jumper wires (2 and 5).

GO TO FRAME 3

7-12