TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 459 of 830

TM 9-2320-209-20-3-1

FRAME 4

1.

2.

3.

4.

5.

6.

Push alternator (1) toward firewall as shown. Front flange (2) on alternator

must be hard against mounting bracket front flange (3).

Put 0.005-inch feeler gage between rear flange (4) on alternator (1) and

mounting bracket rear flange (5). Feeler gage should fit between flanges very

easily.

NOTE

Hold rear of alternator (1) up when sliding bolt (6)

out of rear mounting flange (4) to put in shims (7).

Pull bolt (6) out of rear flange (4) on alternator (1). Slip shim (7) between

alternator flange (4) and mounting bracket rear flange (5). Put bolt back in.

Do steps 1, 2, and 3 again as necessary, adding shims (7) until feeler gage

makes snug fit between shims and alternator flange (4).

Screw two nuts (8) on bolts (6 and 9). Using torque wrench, tighten nuts to

65 to 70 pound-feet.

Using pliers, put two cotter pins (10) through nuts (8) and bolts (6 and 9).

GO TO FRAME 5

7-23