TM-9-2320-272-23-3
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 3 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-3 - Page 1357 of 1469
FRONT SPRING INSTALLATION - Continued
NOTE
Steps (11) through (16) apply to right side of spring only.
11.
Install steering cylinder dust cover (Figure 7, Item 3) on ball stud (Figure 7, Item 2).
12.
Position steering cylinder (Figure 7, Item 7) over ball stud (Figure 7, Item 2).
13.
Tighten cylinder adjusting plug (Figure 7, Item 5) until cylinder (Figure 7, Item 7) does not move on ball stud
(Figure 7, Item 2).
14.
Tighten cylinder adjusting plug (Figure 7, Item 5) slightly more if necessary to align slot with hole in cylinder
(Figure 7, Item 7).
15.
Install cotter pin (Figure 7, Item 6) in steering cylinder (Figure 7, Item 7).
16.
Bend tabs (Figure 7, Item 4) of steering cylinder dust cover (Figure 7, Item 3) around steering cylinder
(Figure
7,
Item
7) and spring hanger (Figure 7, Item 1).
M10314DAA
7
6
4
5
3
2
1
Figure 7.
Steering Cylinder Installation.
END OF TASK
TM 9-2320-272-23-3
0534
0534-10
Back to Top
