TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 451 of 801

TM 9-2320-273-34

11-3. Through Shaft (Output Shaft) Removal and Disassembly.

a. Removal.

(1)

If the unit is in the vehicle, disconnect rear propeller shaft.

(2)

Remove the output shaft nut (fig. 11-3) yoke and washer. It may be necessary to use a yoke

puIler to remove the yoke from the shaft.

(3)

Remove output shaft bearing retainer (cage), capscrews and washers and puII the cage,

shaft, and bearing assembly from the axle housing.

To free the cage from the housing, it may be necessary

to tap the shaft and cage with a soft mallet. Care must be taken not to damage seal. Also, remove the

bearing cage to housing gasket.

b. Disassembly.

CAUTIO N

The spacer diameter must be less than the

outer diameter of the through-shaft to

avoid damaging the oil seal and bearings

in the next step.

Figure 11-3. Remove and Disassemble the Through-Shaft.

11-5