TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 452 of 801

TM 9-2320-273-34

(1)

press the output shaft (fig. 11-3) from the bearing cage by placing the shaft and cage in a

press, cage to the top. Use a spacer against the through shaft threaded end and press the shaft from the

bearings and cage.

NOTE

The oil seal, snap ring spacer and bearings

will remain in the bearing cage. If disas-

sembly is required, continue with step

b;

otherwise set aside for assembly.

(2)

Remove the oil seal from the cage, using a suitable tool such as a screwdriver to pry seal

out. Be careful not to damage the inner diameter of the cage. Discard seal after removal.

(3)

Disassemble the snap ring bearing spacer from its groove in the cage inner diameter us-

ing snap ring pliers.

(4)

Remove both inner and outer bearings (cups and cones) from the cage and spacer washer.

11-4. Differential Carrier Removal.

a. Preparation.

(1)

Remove plug from bottom of axle housing and drain lubricant. Do not remove filter plug.

b. Removal.

CAUTIO N

In step

(1),

do not hit the circular driving

lugs on the shaft head. This may cause

the lugs to shatter and splinter. Do not

use chisels or wedges to loosen the shaft

or dowels. This will damage the hub,

shaft and oil seal.

11-6