TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 461 of 801

TM 9-2320-273-34

(4)

Lift out the interaxle differential nest and case assembly from the carrier housing

(fig. 11-15).

NOTE

The rear side gear and rear input bearing

will remain loose in the carrier housing.

(Refer to step

(7).)

Figure 11-15. Remove and Disassemble Interaxle Differential Case Assembly.

(5)

Before disassembling the interaxle differential case halves and gear nest, match mark the

case halves with a punch for correct alinement at reassembly.

NOTE

In step

(6),

there are washers under

both the capscrew heads and nuts.

(6)

Disassemble the case halves by removing eight rivets.

Remove the spider (cross), four

pinions, and thrust washers.

(7)

Lift out the rear side gear and bearing cone from the carrier housing. The bearing cup will

remain in the carrier. If replacement is necessary, remove the cup using a suitable bearing puller.

(8)

To remove the bearing cone from the rear side gear, place the gear in a press. Use a

suitable sleeve and press the gear from the bearing.

If a press is not available, use a suitable bearing puller.

f. Remove Main Differential and Gear Assembly.

(1)

With the carrier still in an upright position, loosen the jam nut and back off the drive gear

thrust screw.

11-15