TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 191 of 400

TM 9-2320-283-13&P

0023

0023-3

INSTALLATION, AIR TUBE – CONTINUED

1.

Measure and cut bulk tubing to desired length, and route new tube (figure 3, item 1) as noted during

removal.

2.

Slide nut (figure 3, item 2) on tube (figure 3, item 1) with threads (figure 3, item 5) facing end of tube

(figure 3, item 3), and install ferrule (figure 3, item 3) on outside diameter (O.D.) of tube

(figure 3, item 1).

NOTE

If sleeve insert is not contained in fitting, perform step 3 to install

sleeve insert on inside diameter (I.D.) of tube.

3.

Install sleeve insert (figure 3, item 4) on I.D. of tube (figure 3, item 1).

1

2

3

4

5

1

2

3

Figure 3. Installing Nut, Ferrule, and Sleeve Insert.

WARNING

All nylon air line tubing must be connected to fittings with a brass

ferrule and sleeve insert or end of tube will leak or blow off once

under pressure.

Failure to comply may result in damage to

equipment or possible injury to personnel. Seek medical attention in

the event of an injury.

4.

Push end of tube (figure 4, item 1) in fitting (figure 4, item 3) until it bottoms and thread nut

(figure 4, item 2) on fitting (figure 4, item 3). Tighten nut (figure 4, item 2) in accordance with (IAW)

table 1.

Figure 4. Installing Tube Assembly.