TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 189 of 400

0023-1

TM 9-2320-283-13&P

0023

FIELD MAINTENANCE

AIR HOSE AND AIR TUBE REPLACEMENT

Tools

Tool kit, general mechanic’s (WP 0063, Table 2, Item 8)

Materials/Parts

Bulk tubing, 5/8 green (WP 0058, Item 1)

Bulk tubing, 1/2 green (WP 0058, Item 2)

Bulk tubing, 1/2 red (WP 0058, Item 4)

Bulk tubing, 1/2 blue (WP 0058, Item 3)

Pipe joint compound (WP 0066, Item 6)

Tie Strap (WP 0066, Item 10)

References

TM 9-2320-283-10

Equipment Condition

Air reservoirs drained (TM 9-2320-283-10).

WARNING

Ensure all residual air pressure is released from air reservoirs prior to

disconnecting any air hose or tube assembly.

Failure to comply may

result in damage to equipment or possible injury to personnel. Seek

medical attention in the event of an injury.

NOTE

This task covers removal of a rubber air hose and nylon air tube at

one location. All air hoses and air tubing are replace the same way

REMOVAL, AIR HOSE

NOTE

Always disconnect swivel nut end of air hose assembly first.

1.

Loosen swivel nut (figure 1, item 3), and disconnect hose assembly (figure 1, item 1) from flare fitting

(figure 1, item 4).

2.

Loosen opposite end of hose assembly (figure 1, item 1), and remove hose assembly

(figure 1, item 1) from NPT fitting (figure 1, item 2).

1

2

3

4

INITIAL SETUP:

Figure 1. Removing Hose Assembly.

END OF TASK