TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 182 of 400

TM 9-2320-283-13&P

0022

0022-2

0022-2

1

2

3

4

5

6

1

2

3

4

REMOVAL, SENSOR, FRONT AXLE – CONTINUED

NOTE

Note location, size, and quantity of tie straps prior to removal for

installation.

2.

Remove all tie straps from wheel sensor cable (figure 2, item 2). Discard tie straps.

CAUTION

When removing wheel sensor from clamp sleeve, do not pull from

cable or damage to sensor may result.

3.

While holding end of wheel sensor (figure 2, item 3), remove wheel sensor (figure 2, item 3) from

clamp sleeve (figure 2, item 4). If replacing wheel sensor (figure 2, item 3), remove split loom

(figure 2, item 1) from wheel sensor cable (figure 2, item 2).

4.

Remove clamp sleeve (figure 2, item 4) from hole (figure 2, item 5) in front spindle and brake spider

(figure 2, item 6).

Figure 2. Removing Wheel Sensor from Front Axle.

END OF TASK

REMOVAL, SENSOR, REAR-REAR AXLE

NOTE

Note location, size, and quantity of tie straps prior to removal for

installation.

1.

Disconnect wheel sensor cable (figure 3, item 3) from rear wheel sensor harness

(figure 3, item 4) located inside frame rail adjacent to rear modulator (figure 3, item 1). Remove tie

straps from wheel sensor cable (figure 3, item 2) and remove tape and split loom (figure 3, item 3) from

wheel sensor cable (figure 3, item 3). Discard tie straps and tape.

Figure 3. Disconnecting Wheel Sensor Cable at Rear Modulator.