TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 175 of 400

TM 9-2320-283-13&P

0020

0020-3

1

2

3

4

INSTALLATION

NOTE

If removed, perform steps 1 and 2 to install inner and outer bearing

cups. If removed, perform step 3 to install new wheel studs. Perform

step 4 for installation of tone ring.

1.

Install inner and outer bearing cups. Refer to TM 9-2320-283-20.

NOTE

Ensure the same right-hand or left-hand threaded wheel studs are

installed on same hub. Ensure each wheel stud is driven in until

shoulder is fully seated against hub flange.

2.

Position rear hub (figure 3, item 3) facing down on rear brake drum (figure 3, item 4) with wheel stud

holes aligned.

3.

Install new wheel studs (figure 3, item 1) on rear hub (figure 3, item 3) as required.

4.

Install rear tone ring (figure 3, item 2) on rear hub (figure 3, item 3). Refer to WP 0021.

Figure 3. Installing Bearing Cones, Wheel Studs, and Rear Tone Ring.