TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 170 of 400

TM 9-2320-283-13&P

0019

0019-4

1

SEAL INSTALLER

2

3

INSTALLATION – CONTINUED

NOTE

Do not get grease on rear seal shoulder bore of wheel hub when

installing inner bearing cone.

5.

Apply grease to inner bearing cone (figure 5, item 2) and set inner bearing cone (figure 5, item 2) on

inner cup of front hub (figure 5, item 3).

6.

Apply sealant to outside edge of new seal (figure 5, item 1) and position seal (figure 5, item 1) on front

hub (figure 5, item 3) with tapered side of seal facing up.

7.

Using seal installer, drive seal (figure 5, item 1) into shoulder bore of front hub (figure 5, item 3) until

fully seated.

Figure 5. Installing Inner Bearing Cone and Seal.

CAUTION

Be careful not to slide hub seal over threads at end of spindle when

installing hub. Ensure hub is centered when positioning on spindle.

Failure to comply may result in damage to equipment.