TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 169 of 400

TM 9-2320-283-13&P

0019

0019-3

1

2

3

4

5

1

2

3

4

REMOVAL – CONTINUED

Figure 3. Removing Bearing Seal and Inner Bearing Cone.

END OF TASK

INSTALLATION

NOTE

If removed, perform steps 1 and 2 to install inner and outer bearing

cups. If removed, perform step 3 to install new wheel studs. Perform

step 4 for installation of tone ring.

1.

Install inner and outer bearing cups. Refer to TM 9-2320-283-20.

NOTE

Ensure the same right-hand or left-hand threaded wheel studs are

installed on the same hub. Ensure each wheel stud is driven in until

shoulder is fully seated against hub flange.

2.

Position front hub (figure 4, item 1) facing down on front brake drum (figure 4, item 4) with wheel stud

holes aligned.

3.

Install new wheel studs (figure 4, item 3) on front hub (figure 4, item 1) as required.

4.

Install front tone ring (figure 4, item 2) on front hub (figure 3, item 1). Refer to WP 0021.

Figure 4. Installing Bearing Cones, Wheel Studs, and Front Tone Ring.