TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 177 of 400
TM 9-2320-283-13&P
0020
0020-5
1
2
3
4
5
SOCKET
6
INSTALLATION – CONTINUED
CAUTION
Be careful not to slide hub seal over threads at end of axle housing
when installing hub. Ensure hub is centered when positioning on axle
housing. Failure to comply may result in damage to equipment.
8.
Fill cavity in rear hub (figure 5, item 1) with grease and carefully position hub (figure 5, item 1) on axle
housing spindle (figure 5, item 6).
9.
Apply grease to outer bearing cone (figure 5, item 2) and position bearing cone (figure 5, item 2) against
outer cup in rear hub (figure 5, item 1).
10.
Install inner nut (figure 5, item 3) on axle housing spindle (figure 5, item 6) with machined surface
facing out. Using 4-1/8 in. (105 mm) socket, tighten inner nut (figure 5, item 3) to 50 lb-ft (68 N•m)
while rotating hub (figure 5, item 1) back and forth. Back off inner nut (figure 5, item 3) 1/4 to 1/3 turn.
Rotate hub; hub should rotate freely.
11.
Install lockwasher (figure 5, item 4) on axle housing spindle (figure 5, item 6).
12.
Install outer nut (figure 5, item 5) on axle housing spindle (figure 5, item 6) with machined surface
facing out. Using 4-1/8 in. (105 mm) socket, tighten outer nut (figure 5, item 5) to 250–275 lb-ft
(339–373 N•m). Rotate hub; hub should rotate freely.
13.
Alternately bend one tab on lockwasher (figure 5, item 4) against each flat on outer nut (figure 5, item 5).
Figure 5. Installing Rear-Rear Wheel Hub.
Back to Top
