TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 178 of 400
TM 9-2320-283-13&P
0020
0020-6
2
3
4
5
1
1
2
INSTALLATION - CONTINUED
14.
Remove old adhesive from axle shaft flange (figure 6, item 1) and apply adhesive to axle shaft flange
(figure 6, item 1).
15.
Install axle shaft (figure 6, item 5) on rear hub (figure 6, item 2) with eight washers (figure 6, item 3)
and new locknuts (figure 6, item 4).
16.
Position suitable tanker bar to prevent rear hub (figure 6, item 2) from turning clockwise. Tighten eight
locknuts (figure 6, item 4) to 90–120 lb-ft (122–163 N•m).
Figure 6. Installing Axle Shaft.
CAUTION
To protect wheel sensor power cable, ensure split loom is positioned
through enlarged hole in brake spider after positioning wheel sensor.
Failure to comply may result in damage to equipment.
17.
Push in wheel sensor (figure 7, item 1) until it contacts tone ring (figure 7, item 2).
Figure 7. Positioning Wheel Sensor.
END OF TASK
END OF WORK PACKAGE
Back to Top
