TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 180 of 400
TM 9-2320-283-13&P
0021
0021-2
HAMMER
WOOD BLOCK
1
2
3
INSTALLATION
1.
Position front hub (figure 2, item 3) on flat surface with inner bearing end (figure 2, item 2) facing up.
CAUTION
Be careful not to bend or distort tone ring when installing. Do not
strike tone ring with hammer; use a flat block of wood to prevent
damage. Tone ring must turn true with hub after installation. Ensure
tone ring is fully seated on hub. Failure to comply may result in
damage to equipment.
2.
Using flat block of wood and hammer, position front tone ring (figure 2, item 1) on front hub
(figure 2, item 3) and block of wood centered across tone ring (figure 2, item 1).
3.
Carefully drive tone ring (figure 2, item 1) on front hub (figure 2, item 3) until fully seated.
4.
Install front or rear-rear axle hub. Refer to WP 0019 and WP 0020.
Figure 2. Installing Front Tone Ring.
END OF TASK
END OF WORK PACKAGE
Back to Top
