TM 9-2320-328-13&P-1
0109-5
DRAFT
0109
Change 1
.
HWT1519
.
Step 6.
Pull battery disconnect switch to off position (WP 0007).
Connect cab instrument panel
wire harness step lights connector.
Remove one hose bed step light (WP 0234).
Disconnect passenger side body wire harness hose bed step light connector.
Pull
battery disconnect switch to on position (WP 0007).
Turn Service Drive Lights
On (TM 9-2320-422-10).
Put STEP LIGHTS switch to on position (WP 0004).
With a
test lead set, check for 22 to 28 VDC between wire 1615 (green) at passenger side
body wire harness hose bed step light connector, terminal 3 and a known good ground.
.
If 22 to 28 VDC are not present, go to Step 9.
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION