TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

  TM-9-2320-328-13-P-1 - Page 408 of 1318

TM 9-2320-328-13&P-1
0057-28
DRAFT
0057
Change 1
.
HWT0879A
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 39.
Release FOAM SYSTEM switch (WP 0004).
Pull battery disconnect switch to off
position (WP 0007).
Disconnect main wire harness pump operator’s panel 27-pin wire
harness connector.
Remove skid plate grille (WP 0349).
Disconnect main wire harness
main 3 connector.
With a test lead set, check for continuity across main wire harness
wire 2830 (red) from main wire harness pump operator’s panel 27-pin wire harness
connector, terminal 5 to main wire harness main 3 connector, terminal C.
.
a.
If there is continuity, repair wire 2830 in cab pump control wire harness
if repairable (TM 9-2320-325-14&P), or replace cab pump control wire
harness (WP 0281).
.
b.
If there is no continuity, repair wire 2830 in main wire harness if
repairable (TM 9-2320-325-14&P), or replace main wire
harness (WP 0292).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION


Back to Top