TM-9-2330-202-13-P

TRAILER, CARGO, 3/4-TON, 2-WHEEL: M101A1, M101A2 AND M101A3; TRAILER, CHASSIS, 3/4-TON, 2-WHEEL: M116A1 AND M116A2; TRAILER, CHASSIS, 1-TON, 2-WHEEL: M116A3

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

DECEMBER 2011

TM-9-2330-202-13-P - Page 270 of 552

REMOVAL

1.

Support vehicle with suitable lifting devices at front and rear corners on side being maintained.

2.

Remove grease cap (Figure 1, Item 1) from hub (Figure 1, Item 7).

3.

Remove cotter pin (Figure 1, Item 2) from spindle (Figure 1, Item 8). Discard cotter pin (Figure 1, Item 2).

NOTE

Configurations may vary. If trailer has castellated nuts, do Step 4. If trailer is equipped with

retainers and nuts, do Step 5.

4.

Remove castellated nut (Figure 1, Item 3), flat washer (Figure 1, Item 4), and outer bearing (Figure 1, Item 5)

from spindle (Figure 1, Item 8).

5.

Remove retainer (Figure 1, Item 10), nut (Figure 1, Item 9), flat washer (Figure 1, Item 4), and outer bearing

(Figure 1, Item 5) from spindle (Figure 1, Item 8).

6.

Remove hub (Figure 1, Item 7) and brake drum (Figure 1, Item 6), as an assembly, from spindle

(Figure 1, Item 8).

1

2

3

4

5

6

8

7

10

9

M116_M101_4-84

Figure 1.

Hub, Brake Drum, and Wheel Bearing Removal.

END OF TASK

TM 9-2330-202-13&P

0054

0054-2