TM-9-2330-335-14-P
SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)
SEPTEMBER 2008
TM-9-2330-335-14-P - Page 161 of 640
0026-1
TM 9-2330-335-14&P
0026
ORGANIZATIONAL MAINTENANCE
-
CLEARANCE LIGHTS REPLACEMENT
Removal, Installation
WARNING
Disconnect electrical power source before performing any maintenance on the electrical system.
Failure to comply could result in injury to personnel.
NOTE
•
There are nine clearance lights on the semitrailer. The two front clearance lights (Figure 1, Item 2)
are held in place with three self-tapping screws. The seven remaining side and rear clearance lights
(Figure 1, Item 1) use two self-tapping screws each. This procedure removes and installs one front
clearance light; the remaining clearance lights are removed and installed the same way.
•
See WP 0093 for technical data on lighting.
INITIAL SETUP
Maintenance Level
0
Organizational
0
Tools and Special Tools
0
Tool kit, general mechanic’s (Item 4, WP 0082)
0
Materials/Parts
0
Antiseize compound (Item 1, WP 0085)
0
Grease, dielectric (silicone) (Item 7, WP 0085)
0
Screw, self-tapping (20)
0
References
0
Electrical schematic (WP 0023)
0
WP 0093
0
Equipment Conditions
0
Landing legs down
0
Semitrailer disconnected from prime mover
0
Tires chocked
0
Ground boards emplaced
0
2
Back to Top
