TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 334 of 1348

CONDITION/INDICATION

Does multifunction valve supply 125 ± 5 psi (861 ± 34 kPa) through hose 2605?

DECISION

Yes - Go to (Step 6 - Does test equipment pass offset test?) to verify problem is solved.

No - Replace multifunction valve (WP

0086). Go to (Step 6 - Does test equipment pass offset test?) to verify problem

is solved.

STEP 6

Does test equipment pass offset test?

WARNING

Be sure to wear the proper eye protection when working on or around pressurized air systems

if not injury or death could result.

1.

Pull out trailer charge valve in vehicle. Refer to vehicle Operator's manual (WP

0190)

2.

Have assistant turn engine start switch to OFF. Refer to vehicle Operator's manual (WP

0190).

3.

If connected, disconnect TK pressure transducer (blue stripe) from air hose 2605.

4.

If disconnected, connect air hose 2605 to air reservoir 2.

5.

Drain trailer air system. Refer to TM 9-2330-342-10 (WP

0190).

6.

Disconnect air hose 2228 from air bag control valve.

7.

Connect TK pressure transducer (blue stripe) to air hose 2228.

TRANSDUCER

AIR LINE

2228

CONTROL

VALVE

Figure 6.

Air Bag Control Valve and Air Line 2228.

8.

Connect TK pressure test cable to MSD/ICE test equipment (WP

0004) and to TK pressure transducer (blue

stripe).

9.

Perform ICE Offset Test.

CONDITION/INDICATION

Does test equipment pass offset test?

DECISION

Yes - Go to (Step 7 - Does trailer air system maintain a charge?).

No - Test equipment failed offset. Contact your Supervisor.

TM 9-2330-342-23&P

0031

0031-6