TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 1181 of 1364

TM 9-2350-238-20-1
2-203. MAINTENANCE OF FIXED FIRE EXTINGUISHER CONTROL SYSTEM.
This task covers:
a.
Removal
b.
Inspection/Repair
c.
Installation
INITIAL SETUP
Materials/Parts
General Safety Instructions
Lockwasher (4)
Lockwasher
Pull cable control handle antipilferage
seal (2)
Self-locking nut (2)
References
TM 9-2350-238-24P-1
Equipment Conditions
2-928 C0
2
cylinder access cover
removed
2-640 Batteries and battery support
removed
2-952 Seat removed
Handle fire extinguisher cylinders
with care-do not drop.
Never remove main valve head on
top of cylinder fire extinguisher.
Removal of main valve head can
cause serious injury to personnel.
REMOVAL
Turning fire extinguisher valve will discharge C0
2
cylinders.
1
Remove two chain hooks (1) from cylinder release cable sling wire rope (2), driver’s
pull cable control assembly (3), and rear left fender pull cable control assembly (4).
compartment
2-1155


Back to Top