TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 41 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 6 of 26)
NOTE
Clamps
(R)
may
require
flat-tip
screwdriver for removal.
13.
Using 7/16 inch wrench, remove two nuts holding
two clamps (R) to two air cleaner outlet hoses (S)
on each side of powerplant.
Remove hoses.
14.
Put protective covering over air cleaner outlet
elbow (T) and turbocharger elbow (T) on each side
of powerplant.
NOTE
One angle bracket (U) is located on
each side at rear of tank.
15.
Using 9/16 inch socket with 2 inch extension,
remove three screws), lockwashers (W), and
washers (X) securing each angle bracket (U).
Throw lockwashers away.
16.Lift up rear corner of bracket (U) to remove it.
Go on to Sheet 7
TA147932
5-31
Back to Top
