TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 33 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2A ENGINE) (Sheet 22 of 24)
47.
Reaching through upper engine access cover
opening, use 7/16 inch wrench to install bolt (AF)
to hold clevis (AG) to rod end (AH).
48.
Reaching through lower engine access cover
opening, remove four protective coverings from
two priming fuel lines (AJ) and quick-disconnect
fittings (AK).
50.
Reaching through upper engine access cover
opening, remove light rope or heavy masking tape
holding free end of fire extinguisher tubing (AL).
51.
Reaching through upper engine access cover
opening, remove protective coverings from ends of
quick-disconnect (AM) and engine fitting (AN).
49.
Reaching through lower engine access cover
opening, manually connec two priming fuel lines
(AJ) at quick-disconnect fittings (AK) by pulling
back on quick-disconnect fittings (AK) and pushing
them on.
52.
Reaching through upper engine access cover opening, manually connect fire extinguisher quick-disconnect (AM) to
engine fitting (AN) by pulling back on quick-disconnect (AM) and pushing it on.
Go on to Sheet 23
TA147924
5-23
Back to Top
