TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 37 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 2 of 26)
PRELIMINARY PROCEDURES
Park tank on level ground.
Block both tracks at front and rear
Release paring brake (TM 9-2350-260-10)
Place MASTER CONTROL switch to OFF (TM 9-2350-260-10)
Disconnect battery ground straps (page 10-294)
Remove upper engine access cover (page 16-44)
Remove top deck (page 16-20)
Remove transmission shroud (page 9-20)
REMOVAL:
1.
Using 7/16 inch wrench, remove six screws (A)
holding generator air duct (B) to bulkhead wall.
2.
Fasten generator air duct (B) to engine with heavy
masking tape (Item 57, Appendix D) to prevent
damage during powerplant removal.
Go on to Sheet 3
TA147928
5-27
Back to Top
