TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 372 of 783

TM 9-2350-260-20-1-3

ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE)(Sheet 11 of 12)

36. Place wiring harness (A) in position.

37. Place clamp (AU) and clamp (AV), which is hidden,

in position around wiring harness (A).

38. Using 1/2 inch socket with extension, install two

screws and new lockwashers (AW) securing two

clamps (AU) and (AV).

39. Using slip joint pliers, install connector (AX) to

ignition unit (AY).

40. Using 1/2 inch socket with extension, install screw

and new lockwasher (AZ) securing ground strap

(BA) to engine.

41. Place clamp (BB) in position around wiring harness

(A).

42. Using 1/2 inch socket with extension, install screw

and new lockwasher (BC) securing clamp (BB).

43. Using 1 inch wrench, connect connector (BD) to end

of generator (BE).

44. Position connector (BF) in bracket (BG).

45. Using cross-tip screwdriver and adjustable wrench,

install four screws, new lockwashers, and nuts (BE).

46. Using spanner wrench, install connector (BJ).

Go on to Sheet 12

10-360