TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 367 of 783

TM 9-2350-260-20-1-3

ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 6 of 12)

40. Using slip joint pliers, remove electrical connector

(AZ) from ignition unit (BA).

41. Using 7/16 inch socket, remove two screws and

lockwashers (BB) security clamp (BC).

Throw

lockwashers away.

42. Remove clamp.

43. Using 1/2 inch socket, remove nut (BD) securing

clamp (hidden).

44. Remove clamp.

45. Using 1/2 inch socket with extension, remove screw

and lockwasher (BE) securing clamp (BF).

Throw

lockwasher away.

46. Remove clamp (BF).

47. Using

spanner

wrench,

disconnect

electrical

connector (BG) from low voltage protection relay

(BH).

48. Using cutting pliers, cut and remove two plastic

straps (BJ) from cables (BK).

49. Using 3/4 inch wrench, remove nut and lockwasher

(BL).

Throw lockwasher away.

50. Remove three cables (BK).

51. Using flat-tip screwdriver, remove screw (BM).

52. Remove electrical cable (BN).

53. Remove engine wiring harness from engine.

Go on to Sheet 7

TA147387

10-355