TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 369 of 783

TM 9-2350-260-20-1-3

ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE)(Sheet 8 of 12)

2.

Place cable (B) in position on starter (C) as shown.

3.

Using flat-tip screwdriver, install screw (D) securing

cable (B) to starter (C).

4.

Place cable (E) in position on starter solenoid (F).

5.

Place two other cables (G) on starter solenoid (F).

6.

Using 3/4 inch wrench, install nut and new

lockwasher (H).

7.

Using spanner wrench, connect connector (J) to low

voltage protection device (K).

8.

Install two new plastic straps (L) around cables (B),

(E), and (G).

9.

Place connector to ignition unit (N).

10. Place cable (P) and clamp (Q) in position.

11. Using 7/16 inch socket, install two screws and new

lockwashers (R) securing cable (P) and clamp (Q).

12. Place clamp (S)(hidden) in position over cables.

13. Using 1/2 inch socket, install nut securing cables

and clamp (S).

Go on to Sheet 9

TA147389

10-357