TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 371 of 783

TM 9-2350-260-20-1-3

ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 10 of 12)

24. Place wiring harness (A) in position along bottom of

engine.

25. Place three clamps (AD) in position around wiring

harness (A).

26. Using 7/16 inch socket and wrench, install three

screws, new lockwashers, and nuts (AE) securing

three clamps (AD) and wiring harness to engine.

NOTE

Apply silicone compound (Item 32,

Appendix D) to all male connectors in

steps 28 thru 31.

27. Using slip joint pliers, install connector (AF) to hour

meter (AG).

28. Connect electrical lead (AH)(CKT 33) to engine oil

temperature transmitter (AJ).

29. Connect electrical lead (AK)(CKT 509L) to engine oil

temperature thermostatic switch (AL).

30. Connect electrical lead (AM)(CKT 36) to engine oil

pressure transmitter (AN).

31. Connect electrical lead (AP)(CKT 509L) to engine oil

pressure transmitter (AQ).

32. Place clamp (AR)(hidden) in position on wiring

harness (A).

33. Using 1/2 inch socket with extension, install nut

securing wiring harness (A) and clamp (AR).

34. Place two clamps (AS) in position on wiring harness

(A).

35. Using 1/2 inch socket, install two screws and new

lockwashers (AT).

Go on to Sheet 11

TA147391

10-359