TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 370 of 783

TM 9-2350-260-20-1-3

ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE)(Sheet 9 of 12)

17. Using slip joint pliers, install connector (V) to fuel-

water separator control (W).

18. Place two clamps (X) in position around wiring

harness (A).

19. Using 1/2 inch socket with extension, install two

screws and new lockwashers (Y) securing clamps

(X) to engine.

14. Place wiring harness (A) in position.

15. Place two clamps (T) in position around wiring

harness (A).

16. Using 1/2 inch socket with extension, install two

screws and new lockwashers (U) securing two

clamps (T) to engine.

20. Using slip joint pliers, install connector (Z) to fuel

solenoid valve (AA).

21. Using 7/8 inch wrench, install fuel shutoff lead (AB)

to front of engine.

22. Place clamp (AC)(hidden) in position on cable.

23. Using 9/16 inch wrench, install nut securing cable

and clamp (AC).

Go on to Sheet 10

TA147390

10-358