TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 466 of 783

TM 9-2350-260-20-1-3

SHIFTING CONTROL BRACKET ASSEMBLY AND CONNECTING LINK REPLACEMENT (Sheet 2 of 2)

4.

Using 3/4 inch wrench, tighten nut (F) against nut (G).

5.

Using 3/4 inch wrench, remove nut (H) and lockwasher (J).

Throw lockwasher away.

NOTE

If stud (K) cannot be screwed in far enough in step 6, back off nuts (G) and (F) on

stud (K) and repeat step 6.

6.

Using 3/4 inch wrench, turn nut (G) clockwise and screw stud (K) into transmission housing until stud (K) is out of hole

in bracket assembly (C).

7.

Remove bracket assembly (C) from transmission.

INSTALLATION:

1.

Position bracket assembly (C) on transmission.

2.

Using 3/4 inch socket, install two screws (D) and new lockwashers (E).

3.

Using 3/4 inch wrench, turn nut (F) counterclockwise until nut (G) is against bracket assembly (C).

4.

Using 3/4 inch wrench, install nut (H) and new lockwasher (J).

5.

Using one 3/4 inch wrench to hold nut (G) and another 3/4 inch wrench on nut (F), tighten nut (F) against transmission

housing.

6.

Install link (B) in bracket (C).

7.

Using 7/16 inch wrench, install screw (A) through both parts of connecting link (B).

8.

Install shifting control rod (page 11-39).

End of Task

TA146589

11-35