TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 460 of 783
TM 9-2350-260-20-1-3
SHIFTING CONTROL BASE ASSEMBLY REPAIR AND REPLACEMENT (Sheet 5 of 6)
7.
Using screwdriver, install plunger (J), spring (K), and
adjuster (L) into pivot (C).
8.
Use hammer and chisel stake pivot (C) to hold
adjuster (L) in place.
9.
Position link (M) onto shaft (D) and aline hole in link
(M) with hole in shaft (D).
10. Using hammer, install pin (N) through link (M) and
shaft (D).
11. Install pin (P) into base (A).
12. Position quadrant link (Q) onto bracket (R).
Install
pin (S) through quadrant link (Q) and bracket (R)
and, using pliers, install new cotter pin (T) through
pin (S).
13. Take assembled base assembly to driver's station of
tank.
14. Install shims (U) onto mounting blocks (V) exactly as
they were removed.
15. Position base (A) onto blocks (V).
Using 9/16 inch
socket and extension, install two screws, new
lockwashers (W) through base (A) and shims (U)
into blocks (V).
NOTE
If shims were present when base was
removed, go to step 14.
If no shims
were
present
when
base
was
removed, go to step 15.
TA146583
Go on to Sheet 6
11-29
Back to Top
