TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

  TM-9-2350-260-20-1-3 - Page 457 of 783

TM 9-2350-260-20-1-3
SHIFTING CONTROL BASE ASSEMBLY REPAIR AND REPLACEMENT (Sheet 2 of 6)
REMOVAL:
1.
Using pliers, remove cotter pin (A) from pin (B).
Throw cotter pin away.
2.
Remove pin (B) from quadrant link (C).
NOTE
There may be some shims between
base and hull.
These shims are used
to aline base with bracket.
If shims
are present, remove as described in
step 5.
5.
Remove shims (K) from hull floor.
Using pencil and
paper, tag and identify the exact location of each
shim.
3.
Using 9/16 inch socket and extension, remove two
screws, lockwashers, and washers (D).
Throw
lockwashers away.
4.
Remove base (E), guide (F), shaft (G), pivot (H), and
link (J) from tank as an assembly and take it to
bench.
6.
Using pliers, remove cotter pin (L) from pin (L).
Throw cotter pin (L) away.
7.
Remove pin (M) and quadrant link (C) from guide
(F).
TA146580
Go on to Sheet 3
11-26


Back to Top