TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 447 of 783

TM 9-2350-260-20-1-3

SHIFT LINKAGE ADJUSTMENT (Sheet 15 of 20)

109. Using two 9/16 inch wrenches, loosen jamnut (BF).

110. Using 9/16 inch wrench, adjust stud and rod end

bearing assembly by turning rod bearing end (BG)

clockwise or counterclockwise until distance

between centers of rod bearing (BG) and (BH)

measures 5-3/4 inches.

111. Using small diameter wire (Item 82, Appendix D), check to see if rod (BJ) is past holes (BK) and (BL).

If rod (BJ) is

past holes (BK) and (BL), go on to step 112.

If rod (BJ) is not past hole (BK), do steps 113 through 117.

If rod (BJ)

is not past hole (BL), go on to step 118.

112. Using two 9/16 inch wrenches, tighten jamnut (BF) while maintaining 5-3/4 inch measurement and go to step 123.

113. Using 9/16 inch wrench, turn rod bearing end (BG) clockwise until rod (BJ) is past hole (BK).

114. Using two 9/16 inch wrenches, tighten jamnut (BF).

115. Using two 9/16 inch wrenches, loosen jamnut (BM).

116. Using 9/16 inch wrench, adjust stud and rod end bearing assembly by turning rod bearing end (BH) clockwise or

counterclockwise until distance between centers of rod bearing ends (BG) and (BH) measures 5-3/4 inches.

117. Using two 9/16 inch wrenches, tighten jamnut (BM) while maintaining 5-3/4 inch measurement and go to step 123.

Go on to Sheet 16

TA146570

11-16