TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 439 of 783
TM 9-2350-260-20-1-3
SHIFT LINKAGE ADJUSTMENT (Sheet 7 of 20)
33. Using 9/16 inch wrench, remove screw (Y) and
remove shifting rod bearing end (Z) from clevis (AA).
34. Using 9/16 inch wrench, adjust shifting rod bearing
end (Z) clockwise until shifting rod (T) is past hole
(X).
35. Using 9/16 inch wrench, install screw (Y) through clevis (AA) and shifting rod bearing end (Z).
36. Using 9/16 inch wrench, tighten jamnut (R).
37. Using 9/16 inch socket and torque wrench, tighten screw (Y) to 15-20 lb-ft (20-27 N
•
m).
38. Using 9/16 inch wrench, adjust shifting rod bearing
end (U) by turning clockwise or counterclockwise
until screw (S) will slide freely through clevis (V) and
shifting rod bearing end (U).
DRIVER'S STATION
39.
Using 9/16 inch wrench, install screw (S) through clevis (V) and shifting rod bearing end (U).
40.
Using 9/16 inch wrench, tighten jamnut (Q).
41.
Remove locating pin from alignment hole (P).
42.
Using 9/16 inch socket and torque wrench, tighten screw (S) to 15-20 lb-ft (20-27 N
•
m).
Go on to Sheet 8
TA146562
11-8
Back to Top
