TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 435 of 783

TM 9-2350-260-20-1-3

SHIFT LINKAGE ADJUSTMENT (Sheet 3 of 20)

6.

Go to right rear of tank and try to insert locating pin

into alignment hole (C).

If locating pin cannot be

inserted, go to step 7.

If locating pin can be

inserted, go to step 130.

7.

At driver's station, try to insert locating pin into

alignment holes (J) in link (K) and bracket (L).

If

locating pin (J) can be inserted, remove locating pin

(J) and go to step 13.

If locating pin (J) cannot be

inserted, go on step 8.

8.

Using 9/16 inch wrench, remove screw (M).

9.

Manually move link (K) and insert locating pin in

alignment hole (J).

10. Using 9/16 inch wrench, adjust shifting rod bearing end (N) by turning clockwise or counterclockwise until screw (M)

will slip freely through link (K) and shifting rod bearing end (N).

11. Remove locating pin from alignment hole (J).

12. Using 9/16 inch wrench, install screw (M).

Using 9/16 inch socket and torque wrench, tighten screw (M) to 15-20 lb-ft

(20-27 N

•

m).

Go on to Sheet 4

TA146558

11-4