TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 436 of 783
TM 9-2350-260-20-1-3
SHIFT LINKAGE ADJUSTMENT (Sheet 4 of 20)
13. Forward of right ammo rack, try to insert locating pin
into alignment hole (P).
If locating pin can be
inserted, remove locating pin and go to step 43.
If
locating pin cannot be inserted, go on to step 15.
14. Using 9/16 inch wrench, loosen jamnuts (Q) and (R).
15. Using 9/16 inch wrench, remove screw (S).
16. Manually move shifting rod (T) and insert locating
pin into alignment hole (P).
17. Using 9/16 inch wrench, adjust shifting rod bearing
end (U) by turning clockwise or counterclockwise
until screw (S) will slip freely through link (V) and
shifting rod bearing end (U).
18. Using small diameter wire (Item 60, Appendix D), check to see if shifting rod (T) is past hole (W) and (X).
If shifting
rod (T) past holes (W) and (X), do steps 19 thru 22.
If shifting rod (T) is not past hole (W), do steps 23 thru 32.
If
shifting rod (T) is not past hole (X), go on to step 33.
Go on to Sheet 5
TA146559
11-5
Back to Top
