TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 442 of 783
TM 9-2350-260-20-1-3
SHIFT LINKAGE ADJUSTMENT (Sheet 10 of 20)
59. Using 9/16 inch wrench, adjust shifting rod bearing
end (AN) by turning clockwise or counterclockwise
until screw (AM) will drop freely through clevis (AP)
and shifting rod bearing end (AN).
60. Using 9/16 inch wrench, install screw (AM).
61. Using 9/16 inch wrench, tighten jamnut (AE) and
remove locating pin from alignment hole (AC).
62. Using 9/16 inch socket and torque wrench, tighten screw (AM) to 15-20 lb-ft (20-27 N
•
m) and go to step 73.
63. Using 9/16 inch wrench, remove screw (AM).
64. Using 9/16 inch wrench, adjust shifting rod bearing end (AN) by turning clockwise until shifting rod (AJ) is past hole
(AL).
65. Using 9/16 inch wrench, install screw (AM).
66. Using 9/16 inch wrench, tighten jamnut (AE).
67. Using 9/16 inch socket and torque wrench, tighten screw (AM) to 15-20 lb-ft (20-27 N
•
m).
Go on to Sheet 11
TA146565
11-11
Back to Top
